JET 710116K Use and Care Manual download pdf (Page 9)

Assembly

Read and understand all

assembly instructions before attempting

assembly! Failure to comply may cause serious

injury!

Unpacking and Cleanup

1. Finish removing all contents from the shipping

carton. Do not discard the carton or packing

material until the bandsaw is assembled and is

running satisfactorily.

2. Inspect the contents for shipping damage.

Report damage, if any, to your distributor.

3. Compare the contents of the shipping carton

with the contents list in this manual. Report

shortages, if any, to your distributor.

Stand

Attach stand supports to back of cabinet BEFORE

placing saw body on top of cabinet.

Using four M6x16 carriage bolts (C, Fig. 1) and

four M6 nuts (B, Fig. 1) attach the stand supports

(A, Fig. 1) through the saw cabinet. The bolt must

be attached from the inside bottom of the saw

cabinet (fig 1). To do this it is easiest if you tilt the

saw cabinet on it’s front and then install the

hardware.

Place cabinet stand upright on a level surface. If

the surface is uneven then you should level the

stand supports by loosening the nut (B, Fig 1) and

moving the support up or down to prevent the

stand from rocking, then tighten the nuts.

Saw body is heavy! Use

caution when lifting and stabilize until firmly

attached to the stand! Failure to comply may

cause serious injury!

With the aid of a second person, lift the saw body

out of the shipping container and place onto stand

top. Be sure front of saw (with JET logo) faces

stand front (Door Side).

Line up holes in saw body with holes in the top of

the stand. Fasten saw body to the stand with four

M8 x 40 hex cap screws, eight M8 washers, four

M8 lock washers, and four M8 hex nuts.

Mounting the Trunnion Bracket to

the Bandsaw

Attach trunnion support to saw body with two M8 x

40 hex cap screws and two M8 lock washers. See

Figure 2.

Figure 1

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments

JET 710116K Use and Care Manual Page 9

Comments to this Manuals

Related products and manuals for Power tools JET 710116K