JET 577003 Use and Care Manual

Operating Instructions and Parts ManualBelt and Disc SanderModel J-4002 – 1”x42” Belt and 8” Disc SanderWALTER MEIER (Manufacturing) Inc.427 New Sanfo

10Operating instructionsStarting and stopping sanderThe on/off switch (see Figure 8) is mounted in a switch box on the rightside of the sander base.

11Belt table adjustmentsThe belt sander table can be tilted or moved in or out to accommodate the operation being performed. Loosenthe locking handle

12Disc table adjustmentsAdjusting the table angleWARNING: When making adjustments, make sure the motor is discon-nected from the power source.WARNING:

13Changing abrasive belts (continued)Press down on the tracking knob to release belt tension (see Figure 18).Remove the belt from the three pulleys.

14Changing abrasive discs(continued)Align the keyway in the disc hub with the key on the motor shaft(see Figure 22). Install the disc plate on the sh

15Typical operations(continued)Sanding aluminum on the disc unit with the table tilted and using themiter gauge as a guide (see Figure 26).NOTE: Alwa

16Typical operations (continued)Inside curves can be sanded on the upper sanding belt idler wheel (seeFigure 30). The upper cover can either be hinge

17Replacement partsThis section provides exploded view illustrations that show the replacement parts for the 1-Inch Belt / 8-InchDisc Sander. Also pr

18Exploded View of Sander (Belt Sander Parts)

19Item PartNo. Number Description1 564003-1 Hex. Socket Head Screw (M10 x 40 MM)2 564004-1 Flat Washer (12 MM)3 564005-1 Spring4 564006-1 Spacer5 564

2Warranty and ServiceWalter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of ourAuthor

20Exploded View of Sander (Disc Sander Parts)

21Item PartNo. Number Description53 5640711 Hex. Socket Head Screw (M5 x 12 MM)54 5640721 Drive Pulley55 5640731 Key56 5640741 Motor57 5640751 Hex Nu

22Notes

23Notes

24WALTER MEIER (Manufacturing) Inc.427 New Sanford RoadLaVergne, Tennessee 37086Ph.: 800-274-6848www.waltermeier.com

3Table of ContentsCover ...

4General SpecificationsThe JET Model J-4002 sander is designed to serve the varying sanding needs of the professional or the homehobbyist. The sander

5- Misuse of this machine can cause serious injury.- For safety, machine must be set up, used andserviced properly.- Read, understand and follow instr

6This sander should be grounded in accordancewith the National Electrical Code and local codesand ordinances. This work should be done by aqualified

7Setting up the sanderWARNING: For your own safety, do not connect the sander to thepower source until the machine is completely assembled and youhave

8Figure 3. Installing stud in tablebracketFigure 4. Belt table installed and handle in place Figure 5. Dust chutes2. Remove the screw and spring from

9Grounding instructionsWARNING: The sander must be grounded while inuse to protect the operator from electric shock. Makesure that the receptacle is