Operating Instructions and Parts Manual Benchtop 12-inch Disc Sander Model JDS-12B (708432K shown with optional stand 708438 and Canister Filter
10Assembly Stand Assembly (optional accessory) 1. Match the hole patterns in the stand legs with the hole patterns in the stand supports. Mount the
11Adjustments Table Adjustment 1. The table stops have been set-up at the factory. However, if you run into a problem, or want to check the table fo
12Center Point The center point (A, Figure 7) provided with the sander can be used for sanding circles. Slide the center point into the miter slot th
13If you want to run the JDS-12B on 230V refer to the wiring diagram found on the inside of the switch box cover (F, Figure 8). Before hooking up t
14 Troubleshooting Trouble Probable Cause Remedy Sander will not start Sander unplugged from wall, or motor. Check all plug connections. Fuse blown,
15Breakdown for JDS-12B Benchtop Disc Sander
16Parts List for JDS-12B Benchtop Disc Sander Index No. Part No. Description Size Qty 1 ... 612131...Guard Base ...
1751 ... TS-1551021 ...Lock Washer ...M4 ... 2 52 ...
18Open Stand Assembly (Optional Accessory) Index No. Part No. Description Size Qty 1 ... 612141...Stand Leg ...
19Electrical Connections
2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au
20 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.
3 Table of Contents Warranty and Service...
4 Warning Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for any
5 • ALWAYS DISCONNECT THE MACHINE FROM THE POWER SOURCE BEFORE SERVICING. • REDUCE THE RISK OF UNINTENTIONAL STARTING. Make sure the switch is
6 Grounding Instructions Warning: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfunctio
7 230 Volt Operation If 230V, single phase operation is desired, the following instructions must be followed: 1. Disconnect the machine from the p
8 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model J
9 Unpacking Open shipping container and check for shipping damage. Report any damage immediately to your distributor and shipping agent. Do not disca
Comments to this Manuals