JET 708411 Use and Care Manual

Operating Instructions and Parts Manual Oscillating Spindle Sander Model JOVS-10 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVe

10Table Insert 1. Disconnect the sander from the power source, unplug. 2. Choose the insert (A, Figure 4) that most closely matches the diameter of

11Replacing Sanding Sleeve 1. Loosen hex nut (A, Figure 7) with a 26mm wrench, or large adjustable wrench. 2. Slide the sanding sleeve (B, Figure 7

12Troubleshooting Trouble Probable Cause Remedy Sander will not start. Sander unplugged from wall or motor. Check all plug connections. Fuse blown,

13Breakdown for the JOVS-10 Oscillating Spindle Sander

14Parts List for the JOVS-10 Oscillating Spindle Sander Index No. Part No. Description Size Qty 7 ... OVS10-007 ...Power C

15Index No. Part No. Description Size Qty 154 ... JOVS10-154...Tank Lid ...

16Sanding Assemblies

17Parts List for Sanding Assemblies Index No. Part No. Description Size Qty 9 3...O VS 10-0 93 ... W re nc h ...

18Electrical Connections

19

2 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of our Au

20 WALTER MEIER (Manufacturing) Inc. 427 New Sanford Road LaVergne, Tennessee 37086 Phone: 800-274-6848 www.walter

3 Table of Contents Warranty and Service...

4 Warning Wear eye protection. Always keep guards in place and in proper operating condition. Do not operate the machine without the guards for any

5 • USE RECOMMENDED ACCESSORIES. The use of accessories and attachments not recommended by JET may cause hazards or risk of injury to persons. •

6 Grounding Instructions Caution: This tool must be grounded while in use to protect the operator from electric shock. In the event of a malfuncti

7 Introduction This manual is provided by Walter Meier (Manufacturing) Inc., covering the safe operation and maintenance procedures for a JET Model J

8 Unpacking Contents of the Shipping Container 1 Sander 3 Table Insert Rings 2 Spindle Wrenches 1 2mm Hex Wrench 10 Removable Spindles 1/4” x 6” Ste

9 Mounting Sanding Sleeves 1. Thoroughly clean the arbors (A, Figure 1) on all of the spindle assemblies. Also clean the arbor housing on the sander