JET 707100 Use and Care Manual download pdf (Page 19)

Sliding Fence

The sliding fence must be

extended to the left or right when making bevel

cuts. Failure to comply may cause serious injury!

Failure to extend the sliding fence will not allow

enough space for the blade to pass through. This

could result in serious injury. At extreme miter or

bevel angles the saw blade may also contact the

fence resulting in damage to equipment as well as

personal injury.

To adjust the sliding fence (refer to Figure 16):

1. Unlock the fence cam locking lever (A) (shown

locked in Figure 16) by pushing it toward the

rear of the machine.

2. Extend the fence (B) by sliding it out (C) to

ensure that the blade will clear the fence for

degree of the bevel cut selected. Lock the

fence cam locking lever (A) as shown.

Note: Secure the sliding fence in position closest to

the saw blade when transporting the saw.

Miter Cut

Referring to Figure 17:

The sliding compound miter saw has nine positive

miter stop detents (A) located on the saw base.

The stops represent the following miter cut angles:

0, 15, 22.5, 31.6 and 45 degrees left and right. To

make a miter cut:

1. Unlock the miter table by lifting up on the quick-

cam miter table lock (E).

2. Raise the positive stop locking lever (C) up, at

the same time grasp the miter handle (D) and

rotate the miter table left or right to the desired

angle.

3. Release the positive stop locking lever (C),

making sure the lever snaps into place at one

of the miter stop detents (A).

Note: The miter can be set for any angle between

0° and 45° left and right. However, the lever will

only lock into place at one of the nine positive stops

indicated above.

Once the desired miter angle is achieved:

4. Press down on the quick cam miter table

lock (E) to secure the table into position.

If the miter angle desired is not one of the nine

positive stops noted above:

5. Simply lock the table at the desired angle by

pressing down on the quick-cam miter table

lock (E).

Figure 16

Figure 17

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Comments to this Manuals

No comments

JET 707100 Use and Care Manual Page 19

Comments to this Manuals

Related products and manuals for Mitre saws JET 707100