JET 707100 Use and Care Manual download pdf (Page 14)

Adjustments

Before attempting any adjust-

ments, make sure the trigger is released and

remove the power cord from the power source

to avoid injury from unexpected starting or

electrical shock. Failure to comply may cause

serious injury!

Note: Your miter saw was adjusted at the factory.

However, d uring shipment slight misalignment may

have occurred. Check the following settings and

adjust if necessary prior to using this miter saw.

Bevel Stop Adjustments

To avoid injury from

unexpected starting or electrical shock, make

sure the trigger is released and remove the

power cord from the power source.

90°(0°) Bevel Adjustment

1. Set the miter angle to 0° (see Miter Angle on

page 15).

Note: A bevel angle of 0° corresponds to a blade-

to-miter-table angle of 90°.

2. Turn the bevel lock handle (A, Fig. 6) clockwise

to loosen and tilt the cutting arm to the 0° bevel

angle. Turn the bevel lock handle (A)

counterclockwise to tighten.

3. Place a combination square on the miter table

with the rule against the table and heel of the

square against the saw blade.

If the blade is not 90° to the miter table:

4. To adjust, tilt the cutting arm to 45°, loosen the

lock nut (B, Fig. 7) and turn the stop bolt (A,) in

or out accordingly.

5. Tilt the cutting arm back to the right and

recheck alignment.

6. Repeat steps 1–4 if necessary until the blade is

90° to the table, then tighten the lock nut (B,

Fig. 7) to secure the stop bolt (A, Fig. 7).

Bevel Scale Indicators

1. Set the blade to be exactly 90°(0°) to the table.

2. With cross-point screwdriver, loosen two bevel

indicator screws (B, D, Fig. 8).

3. Adjust bevel indicators (A, E, Fig. 8) to the “0”

marks (C, F, Fig. 8) on the bevel scale and

retighten the screws (B, D).

Figure 6

Figure 7

Figure 8

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 35 36

Comments to this Manuals

No comments

JET 707100 Use and Care Manual Page 14

Comments to this Manuals

Related products and manuals for Mitre saws JET 707100