JET 707100 Use and Care Manual download pdf (Page 11)

Assembl

Releasing the Cutting Head

When not in use, lock the

cutting head in the down position. Failure to

comply can cause serious injury or damage

equipment.

Refer to Figure 1.

Unlocking

1. Push down on the switch handle (A).

2. Pull out the hold-down latch (B).

3. Raise the cutting head to the up position.

Locking

Note: When not in use, lock the cutting head in the

down position.

1. Push the cutting head down.

2. Press the hold-down latch (B) in to lock.

Important: Always use the carrying handles when

lifting or moving to avoid damage to the machine.

Installing the Extension Table

Referring to figure 2:

1. Loosen the extension table lock knob (E).

2. Place the extension mounting tube (D) into the

two holes provided in the miter saw base.

3. From underneath the saw, insert one screw (B)

into the mounting tube hole (4) and tighten.

4. Slide the extension table to desired position

and tighten the extension table lock knob (E).

5. Install the right extension table in the same

manner.

Installing the Miter Handle

Thread the miter handle (F, Fig. 2) into the hole

located at the front of the miter table.

Installing the Dust Bag

Referring to Figure 3:

1. Squeeze the metal collar wings of the dust bag (A).

2. Place the dust bag neck opening around the

exhaust port (B), and release the collar wings.

To empty the dust bag, remove from exhaust port,

open zipper on underside of bag and empty into

waste container.

Note: Check and empty bag frequently. Do not wait

for it to get full.

Figure 1

Figure 2

Figure 3

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 35 36

Comments to this Manuals

No comments

JET 707100 Use and Care Manual Page 11

Comments to this Manuals

Related products and manuals for Mitre saws JET 707100