JET 707100 Use and Care Manual download pdf (Page 16)

Adjusting Fence Squareness

Referring to Figure 11:

1. Loosen two fence locking screws (C).

Note: One locking screw is located on each fence.

2. Lower the cutting arm and lock in position.

3. Using a square (B), lay the heel of the square

against the blade (D) and the ruler against the

fence (A).

4. Adjust the fence 90° to the blade and tighten

the two fence locking screws (C).

If the saw has not been used

recently, recheck blade squareness to the fence

and readjust if needed.

5. After fence has been aligned, using a scrap

piece of wood, make a cut at 90º then check

squareness on the piece. Readjust if

necessary.

Positive Stop Miter Angle Adjustment

Referring to Figure 12:

1. Unlock the miter table by lifting up on the quick-

cam miter table lock (A).

2. Raise the positive stop locking lever (C) up; at the

same time grasp the miter handle (B) and rotate

the miter table left or right to the desired angle.

3. Release the positive stop locking lever (C) and

set the miter at the desired angle making sure

the lever snaps into place.

Note: There are nine positive stops into which the

lever will lock.

4. After the angle is selected, press down on the

quick-cam miter table lock (A).

Quick-cam Miter Table Lock Operation

If a miter angle required is not one of nine positive

stops, the miter table can be locked at any angle

between these positive stops by using the quick-

cam miter table lock.

Referring to Figure 12:

1. Unlock the miter table by lifting up on the quick-

cam miter table lock (A).

2. Raise the positive stop locking lever (C) up; at

the same time grasp the miter handle (B) and

rotate the miter table left or right to the desired

angle.

Figure 11

Figure 12

3. Release the positive stop locking lever (C).

4. Press down on the quick-cam miter table lock

(A) until it locks the miter table in place.

Note: The quick-cam miter table lock should lock

the table and prevent it from moving. If adjustment

is needed, see Quick-cam Miter Table Lock

Adjustment on following page.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

JET 707100 Use and Care Manual Page 16

Comments to this Manuals

Related products and manuals for Mitre saws JET 707100