JET 708404 Use and Care Manual download pdf (Page 7)

Insert Plates

1. Always use an insert plate.

2. There are 2 oblong, and 2 round insert plates

included with the machine. The oblong insert

plates are used when the table is tilted for

bevel sanding. Each plate has a notch on the

outer edge to ensure that it is inserted

properly. (See page 9 to determine which

insert plate to use with a particular spindle.)

Setup for 90°

1. Loosen both knobs, (A, Figure 4) and place

the table in the 0° position.

2. Place a square (B, Figure 4) on the table.

Rest the long section of the square against the

sanding drum. The square should be flat

against the table and the sanding drum.

3. If the table needs adjustment loosen both

knobs and tilt the table so that the square is

flat against the table and sanding drum.

4. Make sure the pointer (C, Figure 4) reads 0°.

If the pointer needs adjusting loosen the screw

(D, Figure 4), and adjust to the correct

position.

5. Loosen lock nut (F, Figure 4), adjust the 90°

stop bolt (E, Figure 4) with a 13mm open

wrench so that it rests against the bottom side

of the table, and re-tighten the lock nut (F,

Figure 4) with a 12mm open wrench.

Setup for Bevel Sanding

1. Loosen both knobs (A, Figure 5) and adjust

the table to the desired angle.

2. Tighten both knobs.

Dust Collection

The dust port (B, Figure 5) can be hooked directly

to a 2” hose for dust collection.

See your local JET distributor for the complete line

of dust collectors, as well as Hoses and

Accessories. Customize your installation and

obtain maximum performance with JET dust

hoods, hoses, clamps, fittings, and blast gates.

Figure 4

Figure 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

No comments

JET 708404 Use and Care Manual Page 7