JET 708404 Use and Care Manual download pdf (Page 6)

Unpacking and Setup

Contents of the Shipping Container

(see Figure 1)

1 Spindle Sander

1 Spindle Storage Plate (pre-installed)

1 Insert Storage Plate (pre-installed)

2 Round Opening Inserts (3/4” and 2”)

2 Oblong Opening Inserts (3/4” and 2”)

5 Sanding Spindles & Sleeves (all 100 Grit):

1/4”x6”; 1/2”x6”; 5/8”x6”;

1-1/2”x5-1/2”; 2”x5-1/2”

1 Open End Wrench (10-12mm)

2 Open End Wrenches (14-17mm)

1 Operator’s Manual

1 Warranty Card

Finish removing all contents from the shipping

container, and compare items with the list above.

Contact your distributor or JET if any parts are

missing. Do not discard any shipping material until

the sander is set up and running properly.

Report damage, if any, to your local distributor

and/or shipping company.

Exposed metal surfaces, including spindles, have

been coated with a protectant. Clean these

surfaces with a mild solvent or kerosene. Clean the

spindles. Do not use lacquer thinner, paint thinner,

or gasoline, as these will damage painted

surfaces.

Periodically apply paste wax or other protectant to

the table top to prevent rusting.

Spindle and Insert Storage Plates

See Figure 2.

Clean the insert plates and push the unused

inserts into Storage Plate B. Place spindles in the

opposite Storage Plate A.

Installing Spindles

1. Before inserting the threaded spindle into the

spindle housing, make sure the surfaces are

clean.

2. Thread the spindle counterclockwise into the

spindle housing.

3. Using the provided wrenches, tighten the

spindle nut (A, Figure 3) counterclockwise

while holding the spindle housing flat (B,

Figure 3) with the other wrench. NOTE: Do not

over-tighten the spindle as it may be difficult to

remove after the sanding operation.

Figure 1

Contents of Shipping Container

Figure 2

Figure 3

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Comments to this Manuals

No comments

JET 708404 Use and Care Manual Page 6

Comments to this Manuals

Related products and manuals for Power tools JET 708404