JET 708580 Use and Care Manual download pdf (Page 8)

Adjustments

On-Off Switch

The switch (A, Figure 5) has a switch key that,

when pulled out, allows the switch to be locked in

the off position.

Figure 5

Handle Adjustment

The handle can be adjusted for leverage and

comfort. Pulling the spring loaded handle (A,

Figure 6) away from the head and turning allows

you to change the position of the handle.

Figure 6

Fence Adjustment

The fence can be moved in and out by loosening

the locking handle (B, Figure 4) on the column.

Hold Down Adjustment

The hold down (C, Figure 4) should be adjusted so

it just touches the top of the workpiece and allows

the workpiece to slide left or right. The hold down

can also be taken off and turned over for a thicker

workpiece. To adjust the hold down, loosen the

locking handle (D, Figure 4).

Depth Stop Rod Adjustment

The depth stop rod (B, Figure 5) is provided to limit

the depth of the chisel cut. Adjust the depth stop

rod using the locking handle (C, Figure 5). Lower

the head until the bottom of the chisel is at the

required depth. Lower the depth stop rod until it is

at rest against the base.

180° Head Rotation

Removing the three hex socket cap screws at the

base will enable you to rotate the head and column

180°. Doing this will let the user mortise taller

items.

Chuck Key Holder

The chuck key holder is located on the left side of

the head.

Using Bits with Short Shanks

When using bits with short shanks, it will be

necessary to attach the spindle extension adaptor.

Place an open wrench on the flat part of the motor

spindle. Use the chuck key to unscrew and remove

the chuck. Attach the spindle extension to the

chuck. Replace the chuck with the spindle

extension into the motor spindle.

Chisel and Bit Adjustment

See Figure 7.

Note: Chisels and bits are available as optional

accessories.

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

JET 708580 Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools JET 708580