JET 708580 Use and Care Manual download pdf (Page 7)

7

Assembly

Never connect the machine to

the power source until assembly is completed.

Failure to comply may result in serious injury!

1. Screw the handle (A, Figure 2) into the pinion

shaft (B, Figure 2).

Figure 2

(chisel and bit not provided)

2. Tighten the handle. The handle has a notch

(C, Figure 2) to accommodate a wrench.

3. Use the handle to raise the machine head to

the up position. The handle is spring loaded

and can be repositioned by pulling the handle

away from the machine, and turned to the

desired angle.

4. With the head in the up position press the

hydraulic cylinder onto the two fittings. The

upper fitting (D, Figure 2) is located on the

head. The lower fitting (E, Figure 2) is on the

column.

5. Attach the table to the base using two screws

(A, Figure 3).

6. Insert bar of fence assembly (B, Figure 3)

through the hole in the column. Use the fence-

locking handle (C, Figure 3) to adjust fence

assembly.

7. Attach the hold down (D, Figure 3) to the

vertical post using locking handle (E, Figure 3).

Figure 3

Installing

Make sure the Mortising

Machine is attached to a firm and stable

support surface.

This machine must be fastened to a supporting

surface to prevent it from tipping during operation.

Four holes (A, Figure 4) in the base are supplied

for this purpose.

Figure 4

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments