JET 708404 Use and Care Manual download pdf (Page 8)

Turning the Sander On & Off

Note: Before hooking the sander to the power

source, make sure the switch is in off position.

The sander can be turned on by flipping the switch

to the on position.

There is a removable key in the tip of the switch

that can be removed in the off position. When the

key has been removed the dust collector cannot be

used.

Removing Spindles

Using the provided wrenches, loosen the spindle

nut (A, Figure 6) clockwise while holding the

spindle housing flat (B, Figure 6) with the other

wrench.

Changing Sanding Sleeves

1/4", 1/2" and 5/8"

1. Loosen the clamp (A, Figure 7) with a cross

point screwdriver.

2. Remove the sanding sleeve from the spindle

shaft.

3. Install the new sleeve, making sure to re-

tighten the clamp.

1-1/2" and 2" (optional 3")

1. Loosen the nut (B, Figure 7) with the provided

wrench.

2. Remove the sanding sleeve from the spindle

shaft.

3. Reverse these steps to install the new sanding

sleeve.

Figure 6

Figure 7

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

JET 708404 Use and Care Manual Page 8