JET 708658K Use and Care Manual download pdf (Page 12)

Canister Ki

Assembl

If you purchased Model DC-1100VX-CK Dust

Collector, this section describes the assembly and

installation of the contents of the Canister Kit

(SN 708639B).

Canister Filter

1. Mount the handle onto the canister filter with two

M10 hex nuts, two M10 flat washers, and a M10

lock washer (Figure 10).

2. Mount the canister filter on top of the collector

housing (A, Fig. 5) and tighten the knobs on the

canister filter (Figure 10).

Collector Bag

3. Place the snap ring over the top of the plastic bag

and fold the bag over the ring approximately three

inches, as shown in Figure 11.

4. Insert the snap ring (A, Figure 12) of the collector

bag into the bottom of the housing at an angle.

5. Pull down on the snap ring to make sure it seats in

the housing.

Note: Make sure the snap ring “snaps” into place

in the housing, and also that the plastic bag hangs

down approximately 3 inches so that there are no

air leaks.

Figure 10

Figure 11

Figure 12

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

JET 708658K Use and Care Manual Page 12