JET 708658K Use and Care Manual download pdf (Page 10)

6. Install the housing (A, Fig. 5) to two support

legs (B, Fig. 5) using four M8 x 16 hex cap bolts,

eight M8 flat washers, and four M8 hex nuts (C,

Fig. 5). Be sure hose opening faces fan housing.

Note: For filter bag models only – Before attaching

third support bracket place the hanger bracket (D,

Fig.5) between the support bracket and the

housing. This action is not necessary for canister

filter units.

7. Tighten all nuts and bolts at this time with a 13mm

wrench.

Cone Assembly

Referring to Figure 6:

8. Mount the cone support bracket (E) to the housing

with four M6x12 hex cap screws (F), and tighten

from beneath with four M6 hex nuts (G).

9. Install the cone (H) from beneath using the M8x16

hex cap screw (J), M8 flat washer (K), and M8 hex

nut (L), and tighten.

Hose

Referring to Figure 7:

10. Attach the hose (B) between the collector housing

(A) and the impeller housing (D) with two clamps

(C). Tighten the clamps to secure the hose.

This completes the Base Unit assembly. If you

purchased the DC-1100VX-BK or DC-1100VX-5M

Dust Collector (filter bag versions), continue on the

following page. If you purchased the DC-1100VX-CK

Dust Collector (canister filter version), proceed to

Canister Kit Assembly section on page 12.

Figure 5

Figure 6

Figure 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

JET 708658K Use and Care Manual Page 10