JET 708411 Use and Care Manual download pdf (Page 11)

11

Replacing Sanding Sleeve

1. Loosen hex nut (A, Figure 7) with a 26mm

wrench, or large adjustable wrench.

2. Slide the sanding sleeve (B, Figure 7) off

the drum and replace with a new sanding

sleeve. Note: If the sanding sleeve is not

easily removed, cut the sleeve off and clean

the drum before reinstalling a new sleeve.

3. If you are replacing the sanding sleeves on

the steel spindles, loosen the set screw

found on the arbor nut.

4. Remove sanding sleeve from the spindle

and replace with a new sandin

g

sleeve.

Note: If the sanding sleeve is not easily

removed, cut the sleeve off and clean the

drum before reinstalling a new sleeve.

5. Tighten the set screw.

Dust Collection

In order to collect wood dust, attach a dust

collection hose to the dust port. A variety of JET

dust collectors, air filtration units, hoses and

adaptors, etc. are available that will work

effectively with your new sander. Contact your

local JET Distributor for more information.

Maintenance

The manufacturer recommends replacing the 90

SAE gear lube at 800 hours of use.

1. Open the door on the back side of the

machine to access the drain plug (C, Figure

8). Use a 6mm hex wrench to remove the

drain plug.

2. Refill oil through the oil cap (D, Figure 9

)

.

The oil capacity is two quarts.

3. The oil sight glass (E, Figure 8) should read

between the “high” and “low” marks.

Keep the machine and all attachments clean.

All bearings are permanently lubricated and

require no further service.

Figure 7

Figure 8

Figure 9

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments