JET 708113A Use and Care Manual download pdf (Page 9)

9

Mounting Bandsaw to Stand

The saw body is heavy! Use

caution when lifting! Stabilize until firmly

attached to the stand! Failure to comply may

cause serious injury!

Referring to Figure 2:

1. With the aid of a second person, lift the saw

body (A) and place onto the stand top (B).

Be sure front of saw (with JET logo) faces

stand front (JET logo).

2. Place M8 flat washers (D) on M8x35 hex

cap screws (C) and insert screws through

four mounting holes in the bandsaw and

stand.

3. Secure with four M8 flange nuts (E).

Figure 2

Mounting the Motor

Referring to Figure 3:

1. From the right side of the saw, insert the end

of the motor with the shaft and pulley (A)

through the opening (B) in the casting.

2. Rest the motor on a section of 2x4 placed

between the table and motor and against the

casting of the saw body.

3. Align the two mounting holes on the motor

with the slot and hole on the casting (C and

D). The motor mounting holes should be

visible from the inside of the saw body.

Figure 3

Referring to Figure 4:

4. With a 6mm hex wrench, secure the motor

to the saw body with 2 each M8x25 socket

head cap screws (A), M8 spring washers,

and M8x30 flat washers (C). Do not tighten

at this time.

Note: With the motor sitting on a section of 2x4

(refer to Step 2), the mounting holes can be

easily aligned for screw insertion by lifting on the

pulley (G).

Figure 4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments