JET 708113A Use and Care Manual download pdf (Page 8)

8

Hardware Bag for Stand Assembly

01 – Carriage Bolt M8x16 (40)

02 – Serrated Hex Flange Nut M8 (40)

Hardware Bag for Stand Assembly

Tools Required for Assembly

1 Accurate Straight Edge (approximately 2 ft)

1 Cross-point Screwdriver

1 6mm Hex Wrench

1 10mm Box Wrench

1 13mm Box Wrench

Note: Use of sockets and ratchets will speed

assembly time but are not required.

Assembly

Read and understand all

assembly instructions before attempting

assembly! Failure to comply may cause

serious injury!

The required hardware for all assembly on this

machine is found in the Hardware Bag for Stand

Assembly and Hardware Bag for Saw Body.

Unpacking and Cleanup

1. Finish removing all contents from the

shipping carton. Do not discard the carton or

packing material until the bandsaw is

assembled and is running satisfactorily.

2. Inspect the contents for shipping damage.

Report damage, if any, to your distributor.

3. Compare the contents of the shipping carton

with the contents list in this manual. Report

shortages, if any, to your distributor.

Stand

Referring to Figure 1.

1. Assemble the legs (A) to the table (B). Each

leg requires 6 ea M8 x 16 carriage bolts (C)

and 6 ea M8 flange nuts. Hand-tighten only

at this time.

2. Assemble the long plates (E) to the legs (A).

Each plate requires 4 ea M8 x 16 carriage

bolts (F) and 4 ea M8 flange nuts (G). Hand-

tighten only at this time.

3. Assemble the short plates (H) to the legs

(A). Each plate requires 4 ea M8 x 16

carriage bolts (J) and 4 ea M8 flange

nuts (K).

4. Slip the rubber feet onto the ends of the

legs (L)

5. Ensure that the stand is on a level surface

and all four legs are contacting the surface.

6. Tighten all flange nuts with a 13mm socket

or wrench.

A

B

C

D

A

E

F

E

G

H

H

J

K

L

Figure 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Comments to this Manuals

No comments