JET 414700 Use and Care Manual download pdf (Page 8)

This tool is intended for use on a circuit that has

an outlet that looks like the one illustrated in D,

Figure 2. The tool has a grounding plug that

looks like the plug illustrated in D. Make sure the

tool is connected to an outlet having the same

configuration as the plug. No adapter is

available or should be used with this tool. If the

tool must be reconnected for use on a different

type of electric circuit, the reconnection should

be made by qualified service personnel; and

after reconnection, the tool should comply with

all local codes and ordinances.

Figure 2

7.2 Voltage conversion

To switch the incoming power leads for 230 volt

operation, follow the wiring diagram on the

inside cover of motor junction box. To access

junction box, remove filters and cover (part #1,

section 10.1.1).

The plug on the end of the motor cord must be

replaced with a UL/CSA listed plug rated for

240V.

7.3 Extension cords

The use of extension cords is discouraged. Try

to place equipment within reach of the power

source. If an extension cord is necessary, make

sure it is in good condition and heavy enough to

carry the current your product will draw. An

undersized cord will cause a drop in line voltage

resulting in loss of power and overheating. Table

1 shows correct size to use depending on cord

length and nameplate ampere rating. If in doubt,

use the next heavier gauge. The smaller the

gauge number, the heavier the cord.

Ampere

Rating

Volts

Total length of

cord in feet

Than

Not

Than

120

240

100

200

150

300

AWG

00 06 18 16 16 14

06 10 18 16 14 12

10 12 16 16 14 12

12 16 14 12

Not

Recommended

Extension Cord Recommendations

Table 1

8.0 Operation

8.1 Control switch

Refer to Figure 3.

The green pilot lamp (A) will be illuminated

whenever there is power connected to the

dust collector, not just when the machine is

running. Do not assume that no light means

there is no power to the machine. If the bulb is

bad, there will be no indication. Always check

before use.

Pull out on switch (B) to start machine. Push

switch in to stop.

The safety key (C) prevents unauthorized use of

the machine. Remove this key to deactivate the

switch; insert it to restart.

Figure 3

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

JET 414700 Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools JET 414700