JET 414459 Use and Care Manual Page 1

Operating Instructions and Parts Manual 7-inch Horizontal-Vertical Band Saw Model HVBS-7MW WALTER MEIER (Manufacturing) Inc. 427 New

107.0 Adjustments 7.1 Hydraulic feed selector The hydraulic feed selector is used to control the blade feed rate and to lock the bow in vertical po

113. Set vise to desired angle, re-install nuts and bolts, and tighten the nut and bolt assemblies. 4. Adjust the movable vise parallel to the fixe

12 This machine is designed and intended for use with blades that are 3/4” wide by 0.032” thick x 93” long. Use of blades with difference specificat

13 Figure 17 7.9 Adjusting blade tracking Blade tracking adjustment requires running the saw with the back cover open. This adjustment must be com

14 Figure 20 7.11 Adjusting bow weight Bow weight is one of the most important adjustments of the saw. If bow weight is not set properly, one can e

1510. Keep machine lubricated. See section 9.1, Lubrication. 9.0 Maintenance Disconnect machine from power source before making any repair or adjus

16 10.0 Replacement Parts Replacement parts are listed on the following pages. To order parts or reach our service department, call 1-800-274-6848 M

17 10.1.1 HVBS-7MW Bed Assembly – Exploded View

18 10.1.2 HVBS-7MW Bow Assembly – Exploded View

19 10.1.3 HVBS-7MW Bed and Bow Assemblies – Parts List Index No Part No Description Size Qty 1 ... HVBS7MW-1 ...Coolant Pan

21.0 Warranty and Service Walter Meier (Manufacturing) Inc., warrants every product it sells. If one of our tools needs service or repair, one of ou

20 Index No Part No Description Size Qty 46 ... HVBS7MW-46 ...Stop Rod ...

21 Index No Part No Description Size Qty ... HVBS7MW-91A-2 ...Center Shaft (inside)(S/N: 80910747 and higher) ...

22 Index No Part No Description Size Qty 144 ... HVBS7MW-144...Bearing Bushing ...

23 10.2.1 HVBS-7MW Cylinder Assembly – Exploded View 10.2.2 HVBS-7MW Cylinder Assembly – Parts List Index No Part No Description Size

24 11.0 Electrical Connections

32.0 Table of contents Section Page 1.0 Warranty and Service ...

4 3.0 Safety warnings 1. Read and understand the entire owner's manual before attempting assembly or operation. 2. Read and understand the wa

523. Make your workshop child proof with padlocks, master switches or by removing starter keys. 24. Give your work undivided attention. Looking aroun

65.0 Specifications Model number ...

76.0 Setup and assembly 6.1 Shipping contents 1 Band saw 2 Wheel axles 4 Wheels 4 Split pins 2 Strain clamps 1 Material stop bar 1 Mater

8 Figure 3 Figure 4 Figure 5 6.5 Coolant tank preparation Use of a water-soluble coolant will increase cutting efficiency and prolong blade life.

9used to connect this plug to a 2-pole receptacle as shown in B if a properly grounded outlet is not available. The temporary adapter should be used