JET 710702K Use and Care Manual download pdf (Page 10)

6. Install the housing (A, Fig. 5) to two support

legs (B, Fig. 5) using four M8 x 16 hex cap bolts,

eight M8 flat washers, and four M8 hex nuts (C,

Fig. 5). Be sure hose opening faces fan housing.

Note: For models DC-1200VX-BK1 or DC-

1200VX-BK3 only – Before attaching third support

bracket, place the hanger bracket (D, Fig.5)

between the support bracket and the housing.

7. Tighten all nuts and bolts at this time with a 13mm

wrench.

Cone Assembly

Referring to Figure 6:

8. Mount the cone support bracket (E) to the housing

with four M6x12 hex cap screws (F), and tighten

from beneath with four M6 hex nuts (G).

9. Install the cone (H) from beneath using the M8x16

hex cap screw (J), M8 flat washer (K), and M8 hex

nut (L), and tighten.

Hose

Referring to Figure 7:

10. Attach the hose (B) between the fan housing (A)

and the impeller housing (D) with two clamps (C).

Tighten the clamps to secure the hose.

This completes the Base Unit assembly. If you

purchased the DC-1200VX-BK1 or DC-1200VX-BK3

Dust Collector (filter bag version), continue on the

following page. If you purchased the DC-1200VX-CK1

or DC-1200VX-CK3 Dust Collector (canister filter

version), proceed to Canister Kit Assembly section on

page 12.

Figure 5

Figure 6

Figure 7

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

JET 710702K Use and Care Manual Page 10