JET 577101 Use and Care Manual download pdf (Page 8)

Assembly

Your bench grinder requires only the assembly of

the eye shields and tool rests. For your safety, do

not plug the grinder into a power source until all

adjustments are complete. An adjustable wrench

and a Phillips screwdriver are the only tools you will

need to make all normal adjustments and wheel

changes on this grinder.

Be sure that the bench grinder

is unplugged and the power switch is in the

OFF position.

Do not plug in the grinder to

power until it is inspected for shipping damage,

fully assembled, and moved to it1s permanent

location! Failure to comply may cause serious

injury!

Do not operate this grinder

without all guards and shields in place and in

working order! Failure to comply may cause

serious injury!

Chipped or cracked wheels can

break up and cause serious damage to the

grinder and/or severe injury to the operator!

Regularly inspect wheels for damage!

Assembling the Spark Guard and Eye

Shield Mounting Brackets

Parts needed:

2 Brackets (D) (see Note)

2 Lock Knobs (A)

2 Spark Guards (C) (see Note)

2 1/4" x 1/2" Screws (F)

2 1/4" Flat Washers (B)

2 1/4" Lock Washers (E)

Note: Brackets (D) and spark guards (C) are

marked L (G, Fig. 1) for left side assembly and R

for right side assembly.

1. Assemble the left spark guard and eye shield

mounting bracket using Figure 1 as a guide.

Make sure the spark guard and bracket is

marked L.

2. Assemble the right assembly in the same

manner.

Figure 1

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments

JET 577101 Use and Care Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools JET 577101